AeroWorks Extra 260 User Manual download pdf (Page 70)

70

Finishing

1. Decals supplied with the kit may vary from the

photos below. Cut the pre printed adhesive

backed decals from the decal sheet and apply

where desired. Clean the model surface with

alcohol to allow a good bond to the surface. The

decals may be applied using Windex or a solu-

tion of 1 drop of dish detergent to a cup of water

sprayed on the model to assist in proper posi-

tioning. The water must be pressed out from

under the decal after the decal is in position.

Use a rubber squeegee or a credit card edge to

press the water out.

2. Factory placement of decals.

3. Factory placement of decals.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75

Comments to this Manuals

No comments