AeroWorks Extra 260 User Manual download pdf (Page 13)

13

Aileron Servo Installation

1. The ailerons have been pre-hinged and glued

to the wing panels and are ready for flight. No

other steps are necessary for hinging. Gather

one wing panel, two aileron servos, 1 11” Y

harness, and 1 24” servo extension as shown

below for servo installation.

WING ASSEMBLY

2. Layout the servos, extensions and Y harness

on the wing to test fit the installation and en-

sure servo leads are the correct size.

3. Attach the 24” extension to the outboard servo

lead and secure with safety wire, string, tape,

or other method. Ensure the plugs will not

come apart from vibration or light tension.

4. Fasten the pull string from the outboard servo

hole to the male plug of the servo extension.

Secure with tape so that the string pulls from

the front end of the plug

to assist in drawing

the servo wire through the wing without

hanging up inside the wing.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 74 75

Comments to this Manuals

No comments