AeroWorks Extra 260 User Manual download pdf (Page 4)

12. Attach the extension arm to the carb as shown

below. Use blue loctite on the mounting screws

to ensure they do not come loose from vibration.

Note: It may be necessary to rotate the throttle arm

180 degrees from its stock position before

attaching the extension arm.

13. Set the engine in the mounting rails. It may be

necessary to clamp the engine in place for the

next few steps.

14. Adjust the engine position until the thrust

washer is 4 3/4” away from the firewall.

15. Mark the position of the engine mounting holes

on the engine mount. Mark the center of each

engine mounting hole with a center marking tool

or beveled pencil or pen. Ensure the mark is in

the center of the engine mounting hole.

Note: We recommend the Great Planes

Dead Center Engine Mount Hole Locator

Part #GPMR8130

16. Remove the motor mount from the fuselage. Use

a 5/32” drill bit to drill the engine mounting

holes into the engine mount.

Note: Drill the engine mounting holes as

straight as possible. Use a drill press if availa-

able.

17. Use four 8-32 bolts, four flat washers, and four

8-32 lock nuts supplied with this installation kit

to install the engine to the mount.

1 2 3 4 5 6 7 8 9 ... 12 13

No comments

AeroWorks Extra 260 User Manual Page 4