AeroWorks Extra 260 Instruction Manual download pdf (Page 7)

Aeroworks 30cc Freestyle Extra 260 Assembly Manual 7

6. Go over all hinge gaps to ensure there are no

wrinkles. Excessive wrinkles in the hinge

line can cause binding and or damage to the

covering.

CHECKING GLUE JOINTS

1. Go over all seams and glue joints with thin CA,

this will ensure your model lasts for many sea-

sons to come.

Note: Even if you can visibly see glue on all glue

joints it is still recommended that the joints be

reglued. Due to changes in humidity during

the life of the aircraft glue joints can separate,

it is always recommended that the glue joints

be checked before each flying session.

2. Use thin CA on the front canopy mounting tabs

as shown. DO NOT

install canopy on the fuse

until glue has fully cured. Failure to do so may

cause canopy to be permanently glued to the

fuse.

1. The ailerons have been pre-hinged and glued

to the wing panels and are ready for flight. No

other steps are necessary for hinging.

Required Parts

◊ 2 - Double Truss Carbon Control

Horns- Single Output

◊ 1 - Control Horn Base Plate

◊ 1 - 3” 4-40 Adjustable Pushrod

◊ 2 - 4-40 Ball Links

◊ 2 - 4-40 Bolts

◊ 2 - 4-40 Lock Nuts

◊ 1 - Brass Spacer

◊ 1 - 3mm Flat Washer

Required Parts-Not Included

◊ 1 - Aileron Servo

◊ 4 - Servo Mounting Screws (Micro Fastener

Part number STW0209 recommended)

◊ 1 - 1 1/4” Servo Arm

◊ 1 - 6” Servo Extension

◊ 1 - Aeroworks Safety Clip

Required Tools and Adhesives

◊ 80 Grit Sandpaper

◊ 5 Minute Epoxy

◊ Hobby Knife

◊ Ball Point Pen

AILERON SERVO

INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12 ... 54 55

Comments to this Manuals

No comments

AeroWorks Extra 260 Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Toys & accessories AeroWorks Extra 260