AeroWorks Extra 260 Instruction Manual download pdf (Page 34)

34 Aeroworks 30cc Freestyle Extra 260 Assembly Manual

1. Gather the fuel tank parts as shown below.

Required Parts

◊ 1 - 450cc (15oz) Gas Tank Assembled

◊ 1 - 6 x 130 x 70mm Foam Sheet

◊ 2 - 8 x 450mm Nylon Ties

◊ 7 - 3 x 150mm Nylon Ties

Required Parts -Not Included

◊ 1 - Aeroworks Fuel Line Installation Kit

Required Tools and Adhesives

◊ Pliers

◊ Wire Cutter

◊ Electric Drill

◊ Various Drill Bits for Fuel Dot Installation

◊ 1oz Bottle Gap Filling CA Glue

FUEL TANK INSTALLATION

2. Install the fuel pick up and fuel filler lines to the

fuel tank.

Note: It is recommended you always use a fuel

filter on your gas can, filters should not be

installed inside the airplane. Inline fuel filter

can clog and cause your engine to quit.

Fill

Line

Carb

Vent

Line

3. Use small nylon ties to secure fuel line.

Note: Gasoline will cause the fuel line to expand

over time. Always secure fuel lines with

nylon ties to prevent them from pulling off

during flight.

6. Tighten nylon ties to secure tank in place.

7. Use wire cutter to remove excess nylon tie after

tightening.

4. Thread nylon ties under tank mounting plate and

center in position.

5. Install foam rubber pad for fuel tank to rest on.

Foam rubber will help prevent fuel from foam-

ing or getting air bubbles from engine vibration.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 54 55

No comments

AeroWorks Extra 260 Instruction Manual Page 34